SOFTWARE CONFIGURATION
148
MATRIX 220
When finished, all the Slaves should have been correctly recognized. If not, verify all
device connections and power and then repeat the operation by clicking on the Start
Net Autoset button.
Depending on the application, select one of the Default Internal Network Configura-
tions:
Multidata
,
Synchronized Phase Mode
or
Synchronized PackTrack
.
This selection will open a pre-configured job for the Master reader according to the
selection. Follow the specific application instructions in the following paragraphs.
Summary of Contents for Matrix 220
