RAPID CONFIGURATION
6
MATRIX 220
STEP 4 - X-PRESS CONFIGURATION
Once Matrix 220 is focused at the correct reading distance, you must configure it for
optimal code reading relative to your application.
Aim
1. Enter the Aim function by pressing and holding the X-PRESS push button until the
Aim LED is on.
2. Release the button to enter the Aim function. The aiming system turns on.
3.
Select a single code from your application
. Position the code at the center of the
FOV (equidistant from the aiming indicators.
The reader may start flashing and try to perform autofocus however this will have
no effect on the application specific code; it can be ignored.
Exit the Aim function by pressing the X-PRESS push button once. After a short
delay the Aim function is cancelled and the aiming indicators turn off.
Setup
4. Enter the Setup function by pressing and holding the X-PRESS push button until
the Setup LED is on.
5. Release the button to enter the Setup function. The Setup LED will blink until the
procedure is completed.
The Setup procedure ends when the Image Acquisition parameters are successfully
saved in the reader memory, the Setup LED will stop blinking and Matrix 220 emits
3 high pitched beeps.
If the calibration cannot be reached after a timeout of about 5 (five) seconds
Matrix 220 will exit without saving the parameters to memory, the Setup LED will
stop blinking and in this case Matrix 220 emits a long low pitched beep.
Learn
6. Enter the Learn function by pressing and holding the X-PRESS push button until
the Learn LED is on.
7. Release the button to enter the Learn function. The Learn LED will blink until the
procedure is completed.
The Learn procedure ends when the Image Processing and Decoding parameters are
successfully saved in the reader memory, the Green Spot is activated, the Learn LED
will stop blinking and Matrix 220 emits 3 high pitched beeps
1
.
If the autolearning cannot be reached after a timeout of about 3 (three) minutes
Matrix 220 will exit without saving the parameters to memory, the Learn LED will
stop blinking and in this case Matrix 220 emits a long low pitched beep.
1. The Code Autolearn procedure will not recognize the following symbologies: Pharmacode,
MSI, Standard 2 of 5, Matrix 2 of 5.
Summary of Contents for Matrix 220
