TYPICAL LAYOUTS
73
5
The same configuration can be made to a Host using a TCP/IP Ethernet interface. In this
case the Master is connected to a CBX500 with BM200/210 Host Interface Module installed.
The TCP/IP Ethernet, auxiliary, and ID-
NET™ interfaces are connected as shown in the
figure below.
Figure 65
– ID-NET™ M/S Synchronized Layout with BM200/210 TCP/IP Ethernet Interface to Host
Alternatively, the Master reader can communicate to the Host as a Slave node on a Fieldbus
network. This requires using an accessory Fieldbus interface board installed inside the
CBX500 connection box.
System configuration can be accomplished through the Auxiliary interface of each individual
reader (internal CBX500 9-
pin connector) using the VisiSet™ configuration program or Host
Mode programming. See par. 2.3.1 for details.
Figure 66
– ID-NET™ Fieldbus M/S Synchronized Layout
BM2x0 TCP/IP Ethernet Interface
External Trigger
ID-
NET™ (up to 16 devices - practical limit)
Host
1
3
2
Master
Slave#1
Slave#n
Power
CBX500
Fieldbus Interface
External Trigger (for One Shot or Phase Mode)
ID-
NET™ (up to 16 devices - practical limit)
Host
2
Master
Slave#1
Slave#n
Power
1
3
Summary of Contents for Matrix 300
Page 1: ...REFERENCE MANUAL Matrix 300...
Page 160: ......
