INTRODUCTION
23
2
2.2 INDICATORS AND KEYPAD BUTTON
Figure 17 - Indicators
The following LED indicators are located on the reader:
POWER
blue LED indicates that the reader is connected to the power supply (Figure 17, 1)
NET
yellow LED indicates connection to the on-board Ethernet network (Figure 17, 2)
In normal operating mode the colors and meaning of the five LEDs are illustrated in the
following table:
READY
green LED indicates that the reader is ready to operate (Figure 17, 3)
GOOD
green LED confirms successful reading (Figure 17, 4)
TRIGGER
yellow LED indicates the status of the reading phase (Figure 17, 5)
COM
yellow LED indicates active communication on the main serial port * (Figure 17, 6)
STATUS
red LED indicates a NO READ result (Figure 17, 7)
* When connected to a Fieldbus network through the CBX500, the COM LED is always active, even in
the absence of data transmission, because of polling activity on the Fieldbus network.
During the reader startup (reset or restart phase), these five LEDs blink for one second.
In X-PRESS™ Configuration mode the colors and meaning of these five LEDs are described
in par. 2.5.
The keypad
button (Figure 17, 8), is software programmable. By default it starts the
X-PRESS™ interface for quick installation without using a PC (see chp. 1).
1
2
3
4
5
6
7
8
Summary of Contents for Matrix 450
Page 1: ...MATRIX 450 Reference Manual...
Page 12: ...xii...
Page 160: ...www automation datalogic com...