OM-DRAGON™
5
SYSTEM CONNECTIONS
CAUTION
Connections should always be made with power off!
You can connect the OM-DRAGON™ cradle to the Host through the dedicated
connector, using the cable corresponding to the desired interface type.
CONNECTING AND DISCONNECTING THE
OM-DRAGON™ INTERFACE CABLE
The OM-DRAGON™ can be connected to a Host by means of an RS232, Wedge
or Pen cable which must be simply plugged into the Host connector, visible on the
rear panel of the cradle.
To disconnect the cable, insert a paper clip or other similar object into the hole
corresponding to the Host connector on the body of the cradle. Push down on the
clip while unplugging the cable. Refer to the following figure:
Figure 5 – Connecting/Disconnecting the cable.
Multi-standard interface
RS232, WEDGE, or PEN
Emulation to Host
Power