STEP 2 – INSTALL THE LENS AND ILLUMINATOR
PRODUCT REFERENCE GUIDE
7
CBX500/CBX800 Pinout for P-Series™
The table below gives the pinout of the CBX500/CBX800 terminal block connectors. Use
this pinout when the P-Series™ camera is connected using the CBX500/CBX800.
STEP 2 – INSTALL THE LENS AND ILLUMINATOR
Continue with this step if the camera has no lens or internal illuminator, or you want to
use a lens or illuminator with different characteristics.
If the camera already contains the correct lens and illuminator, continue with Step 3.
CBX500/800 TERMINAL BLOCK CONNECTORS
Input Power
Outputs
Vdc
Power Supply Input V
+V
Power Source - Outputs
GND
Power Supply Input Voltage -
-V
Power reference - Outputs
Earth
Protection Earth Ground
O1+
Output 1 +
O1-
Output 1 -
Inputs
O2+
Output 2 +
+ V
Power Source -External Trigger
O2-
Output 2 -
I1A
External Trigger A (polarity insensi
-
tive)
O3A
CBX500: Strobe/Output 3 (Single Pin
Connection)
I1B
External Trigger B (polarity insensi
-
tive)
- V
Power Reference - External Trigger
O3B
CBX500: Not Used
+ V
Power Source - Inputs
O3A
CBX800: / Output 3+ (Opto-
isolated; See Note)
I2A
Input 2 + or - (polarity insensitive)
O3B
CBX800: Strobe - / Output 3- (See
Note)
I2B
Input 2 + or - (polarity insensitive)
RS232 Interface
-V
Power Reference - Inputs
TX
Transmit
Shield
RX
Receive
Shield
Network Cable Shield
SNGD
Signal Ground
NOTE
The strobe signal connection is shared with Output 3. If a non-zero value is
defined for the external Strobe Pulse Length value (in VPM – Settings –
Camera – General), the strobe is active. If the value is zero, Output 3 is
active.
CAUTION
Do not connect GND and SGND to different (external) ground references.
GND and SGND are internally connected through filtering circuitry which
can be permanently damaged if subjected to voltage drops over 0.8 Vdc.
CAUTION
Disconnect power before removing the cover.
