PREFACE
vi
P-SERIES™
Reseller Technical Support
An excellent source for technical assistance and information is an authorized Datalogic
reseller. A reseller is acquainted with specific types of businesses, application software,
and computer systems and can provide individualized assistance.
All necessary firmware is installed on the P-Series™ camera at the factory. Vision Pro
-
gram Manager (VPM) or Vision Program Manager Lite (VPM Lite) software must be
installed to configure the camera inputs, strobe, general purpose outputs, and internal
illuminators. Installation software can be downloaded from the Datalogic web site.
COMPLIANCE
For installation, use and maintenance it is not necessary to open the camera.
Connect Ethernet and dataport connections to a network which has routing only within
the plant or building and no routing outside the plant or building.
EAC Compliance
Customs Union:
The CU Conformity certification has been achieved; this allows the Product to bear the
Eurasian mark of conformity.
Power Supply
ATTENTION: READ THIS INFORMATION BEFORE INSTALLING THE PRODUCT
This product is intended to be installed by Qualified Personnel only.
This product is intended to be connected to a UL Listed Computer (LPS or “Class 2”)
which supplies power directly to the camera, or a UL Listed Direct Plug-in Power Unit
(rated 10 to 30 V, minimum 1 A) marked LPS or “Class 2.”
CE Compliance
CE marking states the compliance of the product with essential requirements listed in
the applicable European directive. Since the directives and applicable standards are sub
-
ject to continuous updates, and since Datalogic promptly adopts these updates, there
-
fore the EU declaration of conformity is a living document. The EU declaration of
conformity is available for competent authorities and customers through Datalogic com
-
mercial reference contacts. Since April 20th, 2016 the main European directives applica
-
ble to Datalogic products require inclusion of an adequate analysis and assessment of
the risk(s). This evaluation was carried out in relation to the applicable points of the
standards listed in the Declaration of Conformity. Datalogic S.r.l. products are mainly
designed for integration purposes into more complex systems. For this reason it is under
the responsibility of the system integrator to do a new risk assessment regarding the
final installation.
NOTE
Throughout this manual, the name “VPM” is used to refer to the software
installed on the camera, either full VPM or VPM Lite.
