Terminal Interfaces
2-2
PowerScan
®
7000 2D
For example, an IBM AT terminal has a Terminal ID of 003. You would
scan the
Terminal ID
bar code, then
0
,
0
,
3
from the
Programming Chart on
page B-5
of this manual, then
Save
. If you make an error while scanning
the digits (before scanning Save), scan the
Discard
code marked
Discard
on page B-4
, scan the
Terminal ID
bar code, scan the digits, and the
Save
code again.
NOTE
After scanning one of these codes, you must
power cycle your computer.
Supported Terminals
Terminal
Model(s)
Terminal ID
IBM SurePOS
USB Hand Held Imager
128
a
a. Applies to USB models only. It is best to use the Plug and Play bar
codes located in the Quick Reference Guide, to program these inter-
faces, rather than scanning the terminal ID listed in this table.
IBM SurePOS
USB Tabletop Imager
129
a
RS-232 True
000
b
b. Default for RS-232 models
RS-232 TTL
000
Serial Wedge
050
USB COM Port Emulation
130
a
USB PC Keyboard
124
a
USB Mac Keyboard
125
a
USB HID POS
131
a
Terminal ID
Save
Summary of Contents for POWERSCAN 7000 2D Imager
