Enter Configuration
Exit and Save Configuration
Ì$+;Î
DATA FORMAT
Ì$-?Î
77
C
HARACTER
R
EPLACEMENT
disable character replacement
ÌEO0mÎ
This parameter allows up to three characters to be replaced from the barcode read. These
substitutions are stored in memory. To define each character replacement:
c
Read one of the following character replacement codes:
first
character replacement
ÌEO1pÎ
second character replacement
ÌEO2sÎ
third
character
replacement
ÌEO3vÎ
d
From the Code Identifier Table in Appendix
, read the Code Identifier for the desired
code family.
0
= character replacement will be effective for all code families.
e
From the Hex/Numeric Table read two characters corresponding to the Hex value
(
00
-
FE
), which identifies the character to be replaced. For Wedge and USB-KBD
interfaces, it is also possible to read the
Special Key(s)
on page 74.
f
From the Hex/Numeric Table read two characters corresponding to the Hex value
(
00
-
FE
), which identifies the new character to replace. For Wedge and USB-KBD
interfaces, it is also possible to read the
Special Key(s)
on page 74.
FF
= the character to be replaced will be substituted with no character, that is, it will be
removed from the code.
