REFERENCES
165
5.12 CUSTOM DEFAULT CONFIGURATION
Read the following code to set the reader user-defined configuration as custom
default configuration:
Save User-defined Configuration as Custom Default
Ì$+$0ÂÎ
Read the following code whenever you need to restore the custom default
configuration:
Restore Custom Default Configuration
Ì$+$1$Î
5.13 CODE TYPE RECOGNITION
This procedure allows the reader to enter a particular state during which it reads and
transmits to the Host information about the family type of codes unknown to the user
(with the exception of MSI, Code 49 and Code 16k code types). It is also possible to
read and transmit configuration strings without interpreting them.
All codes are read ignoring the check digit.
Follow the given procedure:
c
Read the following code to enter the code type recognition mode:
code type recognition
Ì#+CODEÂÎ
d
Read existing codes whose family type you need to check.
e
Read the following code to return to the reader's normal functioning:
exit code type recognition mode
Ì$-?Î
