REFERENCES
169
5.15 DEFAULT PARAMETERS FOR POS TERMINALS
The default values of the RS-232 and Data Format parameters for POS terminals are
listed in the following table:
NIXDORF
Mode
A
FUJITSU
ICL
Mode
RS-232 Group
Baud Rate
9600
9600
9600
Parity Odd
None
Even
Data Bits
8
8
8
Stop Bits
1
1
1
Handshaking
Hardware (RTS/CTS)
None
RTS always ON
ACK/NACK Protocol
Disabled
Disabled
Disabled
FIFO Disabled
Enabled
Enabled
Inter-Character Delay
Disabled
Disabled
Disabled
RX Timeout
9.9 sec
2 sec
9.9 sec
Serial Trigger Lock
Disabled
Disabled
Disabled
Data Format Group
Code Identifier
Custom
Custom
Custom
Header
No Header
No Header
No Header
Terminator CR
CR
CR
Field Adjustment
Disabled
Disabled
Disabled
Code Length TX
Not Transmitted
Not Transmitted
Not Transmitted
Character Replacement
Disabled
Disabled
Disabled
Address Stamping
Disabled
Disabled
Disabled
Address Delimiter
Disabled
Disabled
Disabled
Time Stamping
Disabled
Disabled
Disabled
Time Delimiter
Disabled
Disabled
Disabled
The table below lists all the Code Identifiers available for the POS terminals:
CODE NIXDORF
Mode
A
FUJITSU ICL
Mode
UPC-A A0
A
A
UPC-E C0
E
E
EAN-8 B
FF
FF
EAN-13 A
F
F
Code 39
M
None
C [code length]
Codabar N
None
N
[code
length]
Code 128
K
None
L [code length]
Interleaved 2 of 5
I
None
I [code length]
Code 93
L
None
None
Industrial 2 of 5
H
None
H [code length]
UCC/EAN 128
P
None
L [code length]
MSI O
None
None
GS1 DATABAR™
E
None
None
Other None
None
None