8
PowerScan
TM
PD7100 Corded
USB Connection —
Connect the reader to a USB port on the termi-
nal/PC using the correct USB cable for the interface type you ordered.
Reference
Figure 2
.
Figure 2. Other Interface Connections
Wand Emulation Connection —
Connect the reader to the appro-
priate port on the terminal/PC using the correct cable for the interface
type you ordered. Reference
Figure 2
.
IBM Connection —
Connect the reader to the IBM port on the ter-
minal/PC using the correct IBM cable. Reference
Figure 2
.
Keyboard Wedge Connection —
The Keyboard Wedge cable has a
‘Y’ connection from the reader. Connect the female to the male end
from the keyboard and the remaining end at the keyboard port at the
terminal/PC. Reference
Figure 2
.
Programming
The reader is typically factory-configured with a set of default features.
Reference
Defaults on page 11
. You can select other options and custom-
ize your reader through use of the instructions and programming bar-
codes available in the Product Reference Guide (PRG). You can view and
download this and other manuals from the website listed on the back
cover of this manual.
NOTE
Some interfaces require the scanner to start in the dis-
abled state when powered up. If additional scanner con-
figuration is desired while in this state, pull the trigger
and hold it for five seconds. The scanner will change to a
state that allows programming with barcodes.
U S
I
e
yb
oar
d
W
ed
ge
W
an
d
or...
or...
or...