Default Configuration
14
PowerScan® PD8530 Family
Default Configuration
RS232 Standard DEFAULT SETTINGS
115200 baud, no parity, 8 data bits, 1 stop bit, no handshake, no protocol,
FIFO enabled, intercharacter delay = 0, intercode delay = 0, serial trigger lock
disabled, serial trigger lock disable character = NUL, serial trigger lock enable
character = NUL, RX Timeout = 10 sec
USB COM Emulation DEFAULT SETTINGS
no handshake, no protocol, FIFO enabled, intercharacter delay = 0,
intercode delay = 0
USB Keyboard Emulation DEFAULT SETTINGS
USA keyboard*, intercharacter delay = 0, intercode delay = 0, FIFO enabled,
keyboard speed = normal
WEDGE Communication DEFAULT SETTINGS
USA keyboard*, CapsLock OFF, CapsLock Auto-Recognition ON, NumLock
OFF, intercharacter delay = 0, intercode delay = 0
IBM USB Interface DEFAULT SETTINGS
device usage = handheld
DATA FORMAT – Symbology Independent Parameters
Custom code identifier disabled, code identifier disabled, code length dis-
abled
Default headers and terminators*:
- RS232: no header, terminator = CR-LF
- USB BULK: no header, terminator = CR-LF
- USB COM: no header, terminator = CR-LF
- USB Generic HID: no header, terminator = CR-LF
- Wedge: no header, terminator = ENTER
- USB Keyboard: no header, terminator = ENTER
- IBM USB: no header, no terminator
DATA FORMAT – Symbology Dependent Parameters
symbology specific format = select all, no headers, no terminators, symbol-
ogy character substitution disabled, symbology character deletion disabled
DATA FORMAT – Concatenation
Concatenation disabled, 2 EAN/UPC codes concatenated, Set First Concate-
nated Code Length 000 = any length, Set Second Concatenated Code Length
000 = any length, Set Third Concatenated Code Length 000 = any length, Set
Fourth Concatenated Code Length 000 = any length, Concatenation with
Intercode Delay disabled, Concatenation Timeout 10 seconds, Concatenation
Failure Transmission = Tx codes causing failure, Transmission after Timeout =
No code transmission, Concatenation Result Code ID = No code Identifier
*The default values of these parameters are set when reading the interface selection.
