MICRO QR CODE
ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
219
Micro QR Code Set Length 1
This feature specifies one of the bar code lengths for "
Micro QR Code Length Control" on
. Length 1 is the minimum label length if in Variable Length Mode, or the first
fixed length if in Fixed Length Mode. Characters can be set from 0001 to 0035 characters
in increments of 0001 (pad with zeroes).
See "
for detailed instructions on setting this feature.
Micro QR Code Set Length 2
This feature specifies one of the bar code lengths for "
Micro QR Code Length Control" on
. Length 2 is the maximum label length if in Variable Length Mode, or the sec
-
ond fixed length if in Fixed Length Mode. Characters can be set from 0001 to 0035 char
-
acters in increments of 0001 (pad with zeroes).
See "
for detailed instructions on setting this feature.
Select Micro QR Code Length 1 Setting
$CMQL1
To configure this feature, scan the ENTER/EXIT PRO
-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu
-
meric characters in
represent
-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0001 = Length 1 is 1 Character
Select Micro QR Code Length 2 Setting
$CMQL2
To configure this feature, scan the ENTER/EXIT PRO
-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu
-
meric characters in
represent
-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 i s 0035 Characters
