Connecting the Base Station
8
QuickScan™ QBT2400
Charging the Batteries
The battery can be charged by connecting the reader directly
to a host through the micro-USB connector available in the
bottom of the handle, as shown.
Alternatively, simply insert the QuickScan into the base. When
the scanner is fully seated in the cradle, it will sound a “chirp”
to indicate that the cradle has detected the scanner connec-
tion.
The LEDs on the base (shown in
) will indi-
cate the status of the battery.
Battery Safety
To install, charge and/or perform any other action on the bat-
tery, follow the instructions in this manual.
Before using the Battery, read “Battery Safety” in
the following section. Datalogic recommends
annual replacement of rechargeable battery
packs to ensure maximum performance.
WARNING
Do not discharge the battery using any device
except for the scanner. When the battery is
used in devices other than the designated
product, it may damage the battery or reduce
its life expectancy. If the device causes an
abnormal current to flow, it may cause the
battery to become hot, explode or ignite and
cause serious injury.
Lithium-ion battery packs may get hot,
explode or ignite and cause serious injury if
exposed to abusive conditions. Be sure to fol-
low the safety warnings listed on the follow-
ing page.
Micro-USB
Connector
