Enter/Exit Programming Mode
150
QuickScan™ I QD24XX
Code 11 Set Length 2
This feature specifies one of the bar code lengths for
Code 11 Length Control
. Length 2 is the maximum label
length if in
Variable Length
Mode, or the second fixed length if in
Fixed Length
Mode. Length includes the bar
code’s check and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length (only one fixed length).
Table 16
provides examples for setting Length 2. See
page 217
for detailed instructions on setting this feature.
Table 16. Code 11 Length 2 Setting Examples
STEP
ACTION
EXAMPLES
1
Desired Setting (pad with
leading zeroes)
00 (Ignore This
Length)
07 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT CODE 11 LENGTH 2 SETTING
4
Scan Two Characters From
Appendix D, Keypad
‘0’ and ‘0’
‘0’ and ‘7’
‘1’ and ‘5’
‘5’ and 0’
5
Scan ENTER/EXIT PROGRAMMING MODE
$CC1.2
Select Code 11 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
Summary of Contents for QuickScan I QD24 Series
