Enter/Exit Programming Mode
Product Reference Guide
189
PDF417 Set Length 1
Specifies one of the bar code lengths for
PDF417 Length Control
. Length 1 is the minimum label length if in
Variable Length
Mode, or the first fixed length if in Fixed Length Mode. Length includes the bar code’s data
characters only. Characters can be set from 0001 to 2,710 characters (pad with zeroes) in increments of 01. Any
value greater than 2,710 will be considered to be 2,710.
See
page 217
for detailed instructions on setting this feature.
$CP4L1
Select PDF417 Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
Summary of Contents for QuickScan I QD24 Series
