DATALOGIC
10
USB INTERFACE CONFIGURATION
The USB interface is compatible with:
-
Windows 98 (and later)
-
Mac SO 8.0 (and later)
-
4690 Operating System
START-UP
As with all USB devices, upon connection, the Host performs several checks by
communicating with the cradle. Before the cradle is ready, the correct USB
driver must be loaded.
For all systems, the correct USB driver for the default USB-KBD interface is
included in the Host Operating System and will either be loaded automatically or
will be suggested by the O.S. and should therefore be selected from the dialog
box (the first time only).
You can now read codes with the associated QuickScan Mobile reader. At this
point you can read the USB interface configuration code according to your
application. Load drivers from the O.S. (if requested). When configuring the
USB-COM interface, the relevant files and drivers must be installed from the
USB Device Installation software which can be downloaded from the web site:
http://www.scanning.datalogic.com.
The cradle is ready.
First Start Up
Connect cradle to Host
Select desired USB interface code
(USB-KBD is default)
Read test codes.
The cradle
is
READY
Load drivers
(if requested)
Load drivers
(if requested)
Successive start-ups will automatically recognize the previously loaded drivers.
