Enter/Exit Programming Mode
Codabar
148
QuickScan™ I QD24XX/QBT24XX/QM24XX
Codabar Set Length 1
This feature specifies one of the bar code lengths for
Codabar Length Control on page 147Cod-
abar Length Control on page 147
. Length 1 is the minimum label length if in
Mode, or the first fixed length if in
Mode. Length includes
the bar code’s start, stop, check and data characters. The length must include at least one data
character. The length can be set from 3 to 50 characters.
provides some examples for setting Length 1. See
for detailed instructions
on setting this feature.
Table 13. Codabar Length 1 Setting Examples
STEP
ACTION
EXAMPLES
1
Desired Setting (and pad
with leading zeroes)
03 Characters
09 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT CODABAR LENGTH 1 SETTING
4
Scan Two Characters From
‘0’ and ‘3’
‘0’ and ‘9’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
$CCBL1
Select Codabar Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
03 = Length 1 is 3 Characters
Summary of Contents for QuickScan QD24 series
Page 188: ...Enter Exit Programming Mode Plessey 178 QuickScan I QD24XX QBT24XX QM24XX NOTES...
Page 220: ...Symbology Selection 210 QuickScan I QD24XX QBT24XX QM24XX NOTES...
Page 302: ...Keypad 292 QuickScan I QD24XX QBT24XX QM24XX A B C D E F...
Page 312: ...Scancode Tables 302 QuickScan I QD24XX QBT24XX QM24XX NOTES...
