Reading Parameters
Enter/Exit Programming Mode
Product Reference Guide
85
Image Capture (QD24XX only)
For information and a list of options for Image Capture, use the Datalogic Aladdin configuration
application, available for free download from the Datalogic Scanning website.
MULTIPLE LABEL READING
In standard (default) mode, when the reader’s aiming system is activated (by a trigger pull,
motion or other method depending on the mode), it then acquires and processes each image in
the area in front of it (the Volume). In this case, the scanner stops processing the image once it
decodes a label. If several labels are present in the volume, only the first label encountered is
decoded and sent.
When Multiple Reading Mode is enabled, the scanner keeps on processing the image until all
the labels present are decoded. The reader then sorts the data from all the bar codes (if config-
ured to do so) before transmitting it.
Multiple Labels per Frame
Specifies the ability of the reader to decode and transmit a set of code labels in a specific vol-
ume and in a single frame of time. When in Multiple Labels per Frame the reader beeps and
turns on the good read LED indication for each code read in a frame.
When Multiple Labels Mode is enabled, ISBT pairing, ABC Codabar pairing, and composites are
not allowed.
DEFAULT
$CSNML00(CR)
Multiple Labels per Frame = Disable
$CSNML01(CR)
Multiple Labels per Frame = Enable
Summary of Contents for QuickScan QD24 series
Page 188: ...Enter Exit Programming Mode Plessey 178 QuickScan I QD24XX QBT24XX QM24XX NOTES...
Page 220: ...Symbology Selection 210 QuickScan I QD24XX QBT24XX QM24XX NOTES...
Page 302: ...Keypad 292 QuickScan I QD24XX QBT24XX QM24XX A B C D E F...
Page 312: ...Scancode Tables 302 QuickScan I QD24XX QBT24XX QM24XX NOTES...
