Cleaning Procedure
34
QUICKSCAN™ QD2590
CLEANING PROCEDURE
Exterior surfaces and scan windows exposed to spills,
smudges or debris accumulation require periodic cleaning
to ensure best performance during scanning operations.
Follow the procedures described in this instruction sheet
to keep your QuickScan device in good operating condi-
tion.
Common Cleaning Solutions
The cleaners and disinfectants listed below are tested for
use on Datalogic’s Quickscan QD2590 Enclosures:
Cleaning enclosure and window surfaces
1.
Moisten a soft cloth with a recommended cleaning
solution. Be sure to apply the solution to your cloth
first. Wring excessive liquid from the cloth.
CAUTION: Do not use abrasive pads or cleaning
agents.
CAUTION: Be sure to turn off power and unplug the
device from electrical outlet before cleaning.
CLEANERS
DISINFECTANTS
Formula 409® Glass & Surface Cleaner Clorox® Bleach (diluted 10:1)
Isopropyl Alcohol 70 %
Hydrogen Peroxide 3%
Windex® Multi-Surface
Dishwashing liquid and water
NOTE: Disinfectants may be harsh on metal.
They are recommended for use only on
enclosures.
CAUTION: DO NOT spray or pour cleaner directly
onto the unit.
DO NOT use solutions in their concentrated form.
DO NOT use aerosols, solvents or abrasives.
DO NOT use paper towels or rough cloths to clean
windows.
