SOFTWARE CONFIGURATION
31
3
3.4 CONFIGURATION
Once connected to Matrix-1000
as described in par. 3.3, you can modify the
configuration parameters as follows:
1.
Press the Calibration Tool button from the Main Menu. Matrix-1000™ will
download its permanent memory configuration parameters with the default
values (if it is the first time) to VisiSet™. The Calibration Tool window will be
displayed together with the Parameter Setup window working in Interactive
Mode (see par. 3.4.1 and par. 3.4.2).
2.
Edit the Matrix-1000
configuration parameters according to your application
requirements.
3.
Use the
Calibration Tool
to fine tune the reading performance. See par. 3.4.2.
4.
Close the Calibration Tool window and disable the Interactive Mode by pressing
the interactive button.
5.
Save the new configuration to the reader permanent memory by pressing the
Send button.
6.
Close the Parameter Setup window and press
Disconnect
on the VisiSet™
menu bar (see Figure 28) or launch
Run
Mode from the VisiSet™ Main menu.
Disconnect
exits closing communication between Matrix-1000
and
VisiSet™, and causes Matrix-1000
to enter Run Mode. The disconnected
reader serial port is now available for other purpose.
Run
command does not close communication between Matrix-1000
and
VisiSet™, and causes Matrix-1000
to enter Run Mode. In this case the
reader output messages are displayed on the VisiSet™ terminal and the
statistics are displayed in the Statistics window (Statistics enabled).
