RHINO-NET™
2
For 2D code reading, the Lynx™ readers are the most suitable readers for the Rhino-NET™
environment:
- connect it with external power supply to COM1 through CAB-327/CAB-362.
2.6.1 Laser Barcode Scanner Warnings
The following directions are general indications to be observed when using a laser barcode
reader with Rhino-NET™. For further information and details, refer to the reader user's
manual.
•
Do not stare directly into the laser beam.
•
Do not remove the laser caution labels from the scanner.
•
Do not pour, spray, or spill any liquid on the scanner.
WARNING
Please read the caution labels and the user's manual of the connected
scanner. Avoid exposure. Laser light is emitted from the scanner’s
aperture. Use of controls, adjustments or performance of procedures other
than those specified herein may result in hazardous visible laser light.
2.7 CONNECTING A SERIAL MOUSE
To take advantage of the Windows environment, a serial mouse can be connected to the
Rhino-NET™ COM2 port to make configuration and selection operations easier.
The mouse driver will be loaded by the Windows operating system. To use another serial
device on the port, you must perform a software reset so that the mouse driver is no longer
associated with the port.
Refer to the documentation received with the serial device for complete instructions.
We recommend the use of a Datalogic serial mouse (part number
94ACC1289
) for a correct
functioning.
14
