User’s Manual
51
Software Keyboard
Keyboard Configuration File
The Configuration file is a text file built in sections to provide the
definitions for the keyboard layouts. Comments can be marked at
beginning of a line with a semicolon (;).
Section [Common]
In this section general settings will be defined.
Certain settings can be overridden explicitly within the definition
sections of the actual keyboard data for the respective keyboard.
These settings are explained separately in a 2nd table.
General Settings
Keyname
Parameter – Info
ImagePath
Directory name for all used Bitmaps within this Cfg. The
specified directory is always searched in the list of the
specified CFG file. A complete path specification is
not
supported.
KBShowOnStart=X
With this parameter a fixed specified Keyboard will be
shown automatically after the start. X stands for the
Keyboard-Number from the Keyboard-Config. For example,
KBShowOnStart=1 always shows the Keyboard from the
Cfg-Section [Keyboard_01].
If no keyboard should be visible at the start, X can be set to a
invalid Number, e.g. 100 or the parameter can be left out.
Summary of Contents for TaskBook
