Dataman Dataman-40Pro User Manual Download

Page: 150 / 174

150

This feature may not be available for some types of programmers.

Use settings according to the last loaded project file

- Automatic YES! options is set by

the settings in project file. One of the setting's item of Automatic YES! is 'Pins of
programmer's ZIF excluded from sensing', which is depend on used programming adapter.
Because it is possible that different programmers use different programming adapters for
same device, this setting will be ignored in this case and in the log window you can find
following sentence:
"None connected pins setting was not accepted due to different programming adapter. Please
use automatic YES wizard again." If this case occur go on master programming site (if you
run PG4UWMC with option 'Use Site #1 project for all Sites') or on programming site which
wrote previous mentioned sentence to log and click on the button 'Setting Automatic YES!
parameters' in Programmer / Automatic YES! options.

Settings of 'Indication of state when software waits for a new device' and 'Enable sound when
ready for a new device' is not stored in project file.

Enabled

- Automatic YES! function is enabled on all connected programming site with

parameters set by PG4UWMC.

Disabled

- Automatic YES! function is disabled on all connected programming site. Use this

setting if you need to use button YES! for starting a next operation with the programmed
device.

Response time

- interval between insertion of the chip into the ZIF socket and the start of

selected device operation. If longer positioning of the chip in the ZIF socket is necessary
select elongated response time.

Device removal hold off time

- time period between you removed device from the ZIF

socket and the time when software starts to check the socket for new device inserted. This
time is in seconds and must be from 1 to 120 (default value is 2 seconds).

Device insertion complete time

- time within all pins of the device have to be properly

inserted after a first pin(s) detected so that the program will not detects incorrectly inserted
device. This interval is in seconds and must be from 1 to 120 (default value is 5 seconds).

Suspend on error

- defines if the Automatic YES! function will be temporary disabled on

error to see result of operation or will going on without suspension.

Indication of state when software waits for a new device:

Not indicated (quiet mode)

- the programmer, regardless of the number of ZIF sockets of

the programmer, does not indicate the state when a device is programmed and the
programmer with software wait for inserting a new device. After an operation with a device
only one of the status LEDs Error or OK lights, in dependence on the result of previous
operation. This LED goes off immediately after detecting removal of a device from the ZIF
socket.

By LED Busy blinking

- the programmer, regardless of the number of ZIF sockets of the

programmer, indicates the state when a device is programmed and the programmer with
software wait for inserting a new device mode by blinking with the LED Busy. After an