Dataman Vali-Flash User Manual
Page 3 of 13
INSTALLATION
1.
To use the USB CompactFlash card reader to validate your devices, please install
the Memorex CompactFlash card reader and the drivers from the CD-ROM.
2.
Once you have installed your CompactFlash™ reader and it’s accompanying
drivers, you can proceed with the installation of the Vali-Flash software.
3.
To install the Vali-Flash software, follow the normal installation procedure used
for all Windows based programs. The installation program should automatically
launch when the CD-ROM is inserted in your CD drive. If for any reason it does
not, then simply RUN “setup.exe” from the CD-ROM.
NOTE: Please make sure you follow the proper Windows operating system
procedures for ejecting hardware when disconnecting the CompactFlash card
reader. Failure to eject or stop the card reader device prior to removing it may
cause the Vali-Flash program to hang or incorrectly read the CompactFlash™
memory. This is only applicable to removing the card reader and not necessarily
the CompactFlash memory unless you are using a PCMCIA card reader.
