108
A-Class
General Resolutions (continued)
If experiencing this
problem…
Try this solution…
Poor print quality:
Check the following possibilities:
•
Check the Leveling Cam for correct adjustment (readjust if
necessary; see Section 5.3.1);
•
Review the print quality controls (adjust if necessary; see
Section 3.5);
•
If using thermal transfer, check the media and ribbon
compatibility (use a recommended combination; see
Section 7.2); or,
•
Check for a dirty Printhead (clean it if necessary; see
Section 5.6.1).
Skips labels when
printing:
Check the following possibilities:
•
Calibrate the printer (see Section 3.4);
•
Adjust the Media Sensor (see Section 3.2); or,
•
If the label format is within 1/8 inch of the media’s edge,
reduce or move the format slightly away.
6.1.2 Warning and Fault Messages
The printer displays messages when the possibility of a problem or an actual fault occurs.
Depending upon the displayed message, find the possible action or solution in the tables
below.
Warning and Fault Messages do not appear when in Menu or Test Mode.
Warning Messages
Displayed for about three seconds, Warning Messages assume a low priority and indicate
a pending change in printer configuration, or an operating condition that could lead to a
fault.
Summary of Contents for A-Class Mark II
