36
Paper Sensor Type
Paper Sensor Side
Gap
Inside
Outside
Mark on Bottom
Inside
Outside
Notch
Inside
Outside
Continuous
Inside
Outside
Ribbon Mode
The Ribbon Mode option allows the user to enable and disable Ribbon Mode and notes the type of
ribbon being used.
Ribbon Mode has three settings:
•
Coated In (CSI) - for thermal transfer printing
•
Coated Out (CSO) - for thermal transfer printing
•
None - for direct thermal printing
Print Adjust
The Print Adjust selection allows for the adjustments of both the darkness and the contrast of print
quality as well as horizontal and vertical adjustments.
Selecting the plus or minus buttons respectively increases or decreases the values.
Changes to the values may also be made by selecting the field and entering the appropriate values
using the numeric keypad. During printing the print adjust screen will be available via an icon in the
mode indicator area of the front display. When paused the icon will be accessible via the home screen
icon.
Note:
Settings that use the word “Adjust” should be considered fine adjustments and are not main
settings.
a.
Darkness
The darkness adjustment is set within the range of -20 to +20. To increase darkness, adjust the
settings in a positive (+) direction.
1.
Enter the appropriate value in the field.
