12
M-Class
3.3 Media Sensor Adjustment
The Media Sensor needs to be positioned so that the printer can detect the presence of media and the top-of-form (except for
continuous stock, where the TOF is set through the front panel.
To adjust:
With media loaded, as described in Section 3.2, grasp the Slide Tab and move the Sensor Eye Mark into position over
media according to the table below.
If loading media, return to the media loading instructions.
Media Sensor Selection and Adjustment
Media Type
Sensor Eye Mark Position
Sensing Required
*
Die-cut
Near the middle of the label
Gap
Notched
Centered over the notch
Gap
Reflective
Centered over the black mark
Reflective
Continuous
Near the middle of the media
Continuous
Summary of Contents for M-Class
