Dataprobe sBB-N15, Installation And Operations

 
  Page 10 

Serial iBootBar  v090212d 

Serial Operation 

Command Line Interface 

The Command Line Interface provides complete setup of all function of the iBootBar.  Some commands of the CLI require administrative rights.  These are 
indicated in the table below. 
 
To access the sBB, connect to the serial port and type Enter, the user will be prompted for Username and Password. The default for both is 

admin 

Outlet Commands 

Command

Description 

Access 

Fact Def 

get outlets 

Returns the status of ALL the outlets the user has rights to.  

User 

get outlet <1-8> 

Returns the status of the designated outlet. The user must have 
rights to the selected outlet. 

User 

set outlet <1-8> <on/off/cycle> 

Sets the selected outlet to the selected state.  The user must have 
rights to the selected outlet.   

User 

set outlet <1-8> name <name> 

Sets the nam e of the selected outlet of the selected iBootBar. 20 
characters max. 

Admin 

Outlet <#> 

get outlet <n> control.on  

set outlet <n> control.on <open/closed> 

Gets or sets the state  that  the control input causes the 
corresponding outlet to turn On.   

Admin 

Open 

get outlet <1-8> initial.state 

set outlet <1-8> initial.state <on/off/last> 

Get or set the initial state of the selected outlet of the currently 
selected iBootBar.  Initial state is the condition of the outlet when the 
iBootBar is powered up.  This command will be ignored if external 
control is enabled with 

set external control enable 

Admin 

Last