PAGE 90
UV119UE - DSP 500 : USER MANUAL - v. 4.0
9 -
56 - TX
PROGRAMMING
F
+
+
5
6
ACCESS FROM LEVEL:
transmitting scale programming
This function allows to communicate PLU data and user-programmable label formats from one
scale to the other linked scales. Since the PLU have an updated memory allocation, i.e. just the
actually present PLU take memory space, only the PLU having the same code as the transmitted
PLU shall be overwritten at the addressed scales. As for label formats, all of them will be
overwritten since they are statistically stored.
Attention
:
use the maximum care in transmitting programming, not to loose valuable
data. Remember that only the PLU having the same code shall be
overwritten to the addressed scale (but all the label formats).
After entering this function press
<ENTER>
to access programming as follows:
5 6 T X P R O G R A M M I N G
P R E S S E N T E R T O S T A R T
Press the key
<ENTER>
again to start the transmission of data to the other link-connected scales. The
message
WAIT
is displayed during the transmission, then the scale returns to the initial function display.
57 - FIND SCALES
5 -
F
+
+
5
7
ACCESS FROM LEVEL:
checking the network linked scales
This function can be used for checking which are the linked scales. Once the search is completed,
the network addresses of the linked scales are displayed by numerical order (including the scale
from which the FIND SCALE function has been selected). Scales resulting absent (as they may be
“off”, disconnected or set to local mode) are signalled on the display by a blank space put instead
of their address.
After entering the function press
<ENTER>
to start scale searching as follows:
5 7 S C A L E S
I N N E T W O R K
n n n n
n
n
n
n
n n n
where:
n
= identifier (address) of scales found on the network
Press
<ENTER>
or
<EXIT>
to return to the initial visualisation.
Summary of Contents for DSP 500
