DI-4730 Hardware Manual
Installation
7
3. Installation
The following items are included with each DI-4730 Data Acquisition System. Verify that you have the following:
•
A DI-4730 data acquisition instrument.
•
6-foot USB cable.
•
5-foot Ethernet cable.
•
AC power supply.
•
A DATAQ Instruments screwdriver for digital signal lead connections.
•
A USB flash drive with WinDaq software and an NIST-traceable calibration certificate. Can also be used for
stand-alone data logging.
If an item is missing or damaged, call DATAQ Instruments at 330-668-1444. We will guide you through the appropri-
ate steps for replacing missing or damaged items. Save the original packing material in the unlikely event that your
unit must, for any reason, be sent back to DATAQ Instruments.
Install W
IN
D
AQ
Software
All software for the DI-4730 can be installed via a download-able executable directly from the DATAQ Instruments
web site. The software is also available on the provided USB flash drive.
1. Disconnect all DATAQ Instruments USB devices from your Computer.
2. Plug the USB flash drive (the USB flash drive is shipped installed on the instrument) into your computer’s USB
port or go to run.dataq.com to download the software.
3. Save the executable (Dataq Software Suite Web Setup.exe) to your local hard drive.
4. Double-click on the executable to extract the program and begin software installation.
5. Follow the on-screen prompts and enter all required information.
6. Software installation is complete - you will now see a “Successful Installation” box - click
OK
to exit W
IN
D
AQ
Installation.
