DI–710 Series and DI-715B Series Hardware Manual
Introduction
1
1. Introduction
Congratulations on your purchase of the DI-710 or DI-715B data logger/data acquisition system. DI-710 and DI-
715B Instruments feature a variety of options—each explained fully in this manual. Options include a USB or Ether-
net Interface, PGL or PGH gain settings, Stand-alone capability, and, for DI-715B instruments, thermocouple temper-
ature measurment capability using DI-5B47 modules. DI-715B models accept DI-5B Industrial Signal Conditioning
Modules. Use the table below to determine the options included with your Instrument.
Features
The
DI-710
has the following features:
•
Multiple Hardware options: USB or Ethernet Interface; PGL or PGH gain settings; and Stand-alone data logger
Operation capabilities. All options available in any configuration.
•
Per channel software-configurable settings: Single-ended or differential input; input gain; and calibration.
•
4,800 samples/second maximum sampling rate—up to 14,400 samples/second when recording to a memory card.
•
0.048 samples/second minimum sampling rate—0.0017 samples/second when recording to a memory card.
•
14-bit A/D converter for high resolution measurement accuracy.
•
16-entry input scan list allows you to scan any sequence of input channels at any available gain.
•
The Stand-alone option allows the user to configure a recording session through their PC then record data in the
field to a memory card (SD or MMC)
without
being connected to their PC.
The
DI-715B
has the following features:
•
Accepts up to 8 DI-5B Modules accommodating virtually any industrial signal.
•
Per channel software-configurable settings: input gain settings of 1, 2, 4, 8; calibration.
•
4,800 Hz maximum sampling rate—up to 14,400 Hz when in Stand-alone data logger operating mode.
•
0.048 samples/second minimum sampling rate—0.0017 samples/second when recording to a memory card.
Model No.
Options
Ethernet
USB
-H Gain
-L Gain
Stand-alone
Accepts 5B Modules
DI-710-UH*
N
Y
Y
N
N
N
DI-710-UHS*
N
Y
Y
N
Y
N
DI-710-UL*
N
Y
N
Y
N
N
DI-710-ULS*
N
Y
N
Y
Y
N
DI-710-EH*
Y
N
Y
N
N
N
DI-710-EHS*
Y
N
Y
N
Y
N
DI-710-EL*
Y
N
N
Y
N
N
DI-710-ELS*
Y
N
N
Y
Y
N
DI-715B-E
Y
N
Y
N
N
Y
DI-715B-ES
Y
N
Y
N
Y
Y
*All DI-710 models available with a 37-pin D sub connector (as opposed to two removable 16-port screw termi-
nal blocks). Add “D” to the model number. See "37-pin D sub connector" on page 23.