DI–710 Series and DI-715B Series Hardware Manual
Installation
15
5.
Click on the Add IP button (either in the
No Devices Found
dialog box or in the main
Dataq Instruments Instal-
lation
dialog box). This will display the
Manage IP Addresses
dialog box.
6.
Click on the MAC address of your device in the list of displayed MAC addresses (the MAC address of your
device can be found on the silver sticker located on the bottom of your device).
7.
Enter the IP address your system administrator assigned to you in the
New IP Address
text boxes.
8.
Click on the
Set Static
button. Your device will appear in the list of devices to install allowing you to continue
your W
IN
D
AQ
installation at Step 14. It may take more than 15 seconds for your device to appear in the list. If
you get a “No Devices Found” error after following the above instructions, click the
Retry
button until the
device appears in the list.
Note: These instructions change the settings inside the device. If you move the device to a DHCP-enabled network
(i.e., where IP addresses are assigned automatically by a DHCP server or router) you will need to change the device
settings using the Dataq Instruments Hardware Manager. See the Dataq Instruments Hardware Manager help file for
complete details.