DI–710 Series and DI-715B Series Hardware Manual
Accessories
43
Using the DI-705 with DI-715B Instruments
Plug the DI-705 into CABL-7 and connect CABL-7 to the EXPANSION port on the rear panel of the DI-715B to
access the Digital I/O and analog channels 9-16. Digital I/O may also be accessed through a DI-75B channel
expander using the EXPANSION OUT port on the rear panel of the DI-75B-7. The screw terminals accept 16-22
gauge wire and each is silk-screened with a pin number (below).
The DI-715B accepts single-ended inputs only. The Digital I/O may be enabled as Channel 17.
Note: The Digital I/O
is not available in stand-alone mode.
Pinout for the DI-705 is as follows (screw terminal in
bold
).
1
N.C.
11
CH8
21
DI6
31
CH15
2
DI5
12
CH7
22
DO2
32
CH14
3
DO3
13
CH6
23
DO0
33
CH13
4
DO1
14
CH5
24
DI2
34
CH12
5
DI3
15
CH4
25
DI0
35
CH11
6
DI1
16
CH3
26
DO4
36
CH10
7
Power GND
17
CH2
27
DO7
37
CH9
8
DO6
18
CH1
28
AGD
9
N.C.
19
AGD
29
DI7
10
DO5
20
DI4
30
CH16
Note: Digital I/O connections cannot be used concurrently. DI0 and DO0 are
directly connected inside the DI-715B (as are DI1 and DO1, DI2 and DO2, etc.).
Signal connections are made
to the screw terminals.
Connect to EXPANSION on
DI-715B or EXPANSION
OUT on DI-75B.
