AP25 Installation and Operating Guide
Page 42
AP25 Installation & Operating Guide
Document # 9301H79500 Ver. 1.00
Figure 20. Parametric EQ Screen, Filter Enabled
2.12 Copy EQ Set to Another EQ Set
This screen is used to copy the EQ settings for all channels to a new EQ set under a new name. After
equalizing all the channels, copy these settings to create another EQ (with a new name).
Menu (System) > Formats > Audio EQ Setup > Edit EQs
Figure 21. Copy EQ Settings
Use the
Copy EQ
function, accessible from the
Edit EQs
menu to copy the EQ set. Select the
Copy
EQ From
set (select from the dropdown menu), then in the
to new EQ
field
,
enter a new name for the
EQ set, then click the
Copy
button.
2.13 Final Adjustments
After performing the EQ, take another SPL level reading. If the SPL reading has changed, use the Level
control (Third Octave EQ screen) to raise or lower to the proper SPL level for each channel (see Table
10 on page 38).
