XD20 Installation and Operating Guide
Version 1.1
Appendix E. TCR Head Brackets
E-2
Document #: 9301H264001.1
Timecode Reader Head Mounting Brackets - Description
•
D616 - AA2 bracket (35mm only)
For Norelco AA projectors. Comes with the following hardware:
Qty Description
2 #10
lock
washers
3
5/16 in. x 18 x 5 in. long screws
3
3/8 in. split ring lock
2
10 x 24 x ½ in. long screw
•
D617 - DP75 Bracket (35mm only)
Used to mount the timecode reader head to the side of the projector. Comes with same
hardware as the D614. See also D628 - “L” adapter panel, below.
•
D622 - Front Mount Bracket (35mm only)
Used when installing multiple digital sound heads or when there is not enough room to lift
the projector arm. Used with Dolby SR-D
TM
and Sony SDDS
TM
reader heads.
•
D625 - 35mm / 70mm Standard Bracket – used with breakaway plates.
For projectors
:
Century, Simplex, and Cinemeccanica with Kelmar bracket (see below).
Intended to fit between the projector and reel arm. We have produced the bracket with the
American standard size hole to accommodate 2” center spacing 3/8 - 16 tap, that is utilized
to mount the American made upper reel arms. Comes with the following hardware
:
Head
Qty
Description
35mm
2
10 x 24 x ½ in. long screw
35mm
2
¾ x 16 x 1 in. long hex bolt nut
35mm / 70mm 2
3/8 in. lock washer
70mm
2
3/8 x 1-1/2 in. long cap screws
70mm
2
3/8 in. flat washers
70mm
2
3/8 in. hex nuts
•
D626 - Spacer Breakaway Plate
– used
to mount 35mm reader to 35/70 brackets
•
D627 - Spacer Breakaway Plate
– used
to mount 70mm readers to 35/70 brackets
•
D628 - “L” adapter panel (35mm / 70mm)
– used with D617 and breakaway plates
Used to mount the timecode reader head to the side of the projector. Comes with same
hardware as the D614. D628 is used to adapt the D617 for use with the breakaway plates
(D628 attaches to D617).
•
5006 0001 00 - Cinemeccanica Bracket / adapter plate (35mm only)
For Cinemeccania projectors. Must be used with the D614 standard bracket for mounting the
timecode reader head. If the reel arm needs to be remounted, two plates are required.
Note
: Cinemeccanica also provides its own brackets. Contact them directly.
