XD20 Installation and Operating Guide
Version 1.1
Document # 9301H264001.1
25
3.2.1.1. Start Playlist Functions
Playback
→
Video
→
Start
Slide Loop
Start slide loop playlist.
Preshow
Start preshow playlist.
Intermission
Start intermission playlist.
Playlist C
Start playlist C.
Playlist D, E, F, G
Start playlist D, E, F, or G.
Exit Menus
Return to the status display.
To start a playlist, scroll to the desired playlist type and press
Enter.
The selected playlist will begin and
the asterisk will move to the left of the selection.
All of these playlist functions are also available as automation controls.
The playlist will not start while the XD20 is receiving timecode or the Video Inhibit signal is active.
Provided that the start command has been given through automation, the XD20 will automatically start
after timecode has stopped for 10 seconds as long as the timecode ends within one minute of the
command being given.
Note
: If no playlist is loaded, the XD20 executes the entire automation sequence (lamp on,
start pulse, lamp warm-up delay) without playing any video.
3.2.1.2. Stop Playlist
Playback
→
Video
→
Stop
Stop
Immediately
s
tops the playlist that is currently playing.
Stop at End
Stops the playlist that is currently playing once it reaches the end of the
current clip.
Exit Menus
Return to the status display.
These functions are also available as automation controls.
3.2.1.3. Video Control
Playback
→
Video
→
Control
