4209-00009-000 EasyRead (DSV3-EP) User’s Manual
Rev 0E
6/29/2009
29
Copyright © 2009 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
The passport must continue to be held against the reader until
all the data from the smart card IC has been completely read.
At this point, the dialog box on the Home tab indicates “Read
complete”, and the systems beeps three time.
The system will automatically move to the ICAO tab, where
the photo and biographical data are displayed.
The operator may now select other tabs as desired or may
remove the passport and scan a new one. The scanner may
timeout (taskbar turns orange) and stop scanning after two
minutes of non-activity following a read. In this case, press F4
to restart the scanner.
Some of the additional information available on the ICAO tab
shows the authentication results. This information is available
via the Colored Authentication Results Indicators at the bottom
right. The table below summarizes the available Passive
authentication (PA) and active authentication (AA) results:
Authentication
LED State
Meaning
AA green:
AA successful
AA red:
AA failed *
AA orange:
AA not performed
PA green:
PA successful
PA red:
PA failed *
PA orange:
PA not performed
Audio Feedback:
•
Successful Passport Read:
Three beeps will be played consecutively upon the successful reading
of the electronic content from the presented passport. The user can remove the presented passport
when the beeps sound and the contents will be displayed on the screen. This audio feedback
indicates that the passport read was completed.
•
Security Requirement not Fulfilled:
A sound (exclamation) is heard in the cases of non-
fulfillment of security requirements. Listed below are some possible security requirement issues.
Following a scan or read failure, the scan mechanism is initiated to restart the read cycle.
§
BAC passport presented to the contactless smart card reader without first scanning the MRZ
§
MRZ mismatch between the scanned passport MRZ and the presented passport
§
Premature termination of RF coupling between the passport and the reader during read
initialization.
Errors and Event Logging:
Should any errors be encountered during an ePassport inspection procedure,
it is recommended to remove the passport and try again. If the same errors are experienced, the operator
may activate event logging from the Settings tab and repeat the inspection procedure. Send the generated
textual log found in the Application folder to the Datastrip support team for review.
Colored Authentication
Results Indicators
