4209-00009-000 EasyRead (DSV3-EP) User’s Manual
Rev 0E
6/29/2009
36
Copyright © 2009 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
14
Magstripe Reader Peripheral (Optional)
The Magstripe Reader is an optional module available for the EasyRead and EasyVerify terminals. It is a
factory installed module that is mounted to the bottom of the terminal. It is housed in the same peripheral
housing as the contact smart card reader (see section 13). The docking interface is replicated on the
bottom of the peripheral so that the terminal equipped with a magstripe peripheral may be used with the
docking station.
The media or credential being read must have the magnetic stripe facing up to be read properly.
15
Docking Station
The docking station is an optional peripheral available for the DSV3 mobile terminals and can be adjusted
to for each variant of the mobile terminal. The docking station has the following attributes:
•
Wired I/O Access:
Provides convenient access to the wired I/O ports on the mobile terminal
when docked.
§
USB 2.0 Host: standard A (x2)
§
USB 2.0 Client: standard B (x1)
§
Ethernet: 10/100 RJ45 (x1)
§
RS-232 DB9 (x1)
•
Battery Charging:
Supplies power to charge the batteries inside the mobile terminal
•
Storage:
Provides a convenient place to store the mobile terminal with “grab and go” access.
The docking station mates with the DSV3 terminal via a high
density connector located on the bottom of the terminal. There
are two guide holes on the terminal (and corresponding guide
posts on the docking station) that make it easy to dock and
remove the mobile terminal while providing robust and rugged
connectivity.
Guide Holes
High Density Connector
for Docking Station
Slide the Mag Stripe Card Through the Reader:
Mag Stripe Facing Upward
