9
3. Turn the hard drive connected to the PCBA board to its backside. Locate
two larger HDD screws enclosed inside the package. Tighten the screws in
its appropriate holes, ensuring that the hard drive and PCBA alignment is
properly maintained.
The smaller Case screws are for fastening the Enclosure’s housing
and lid together.
4. Carefully align the PCBA board, with the hard drive attached, to the
Enclosure port opening(s) inside the Enclosure. The two holes of the HDD
end, where it is not attached to the PCBA, will match up to the ribs inside
the housing.
Summary of Contents for AT-S111
Page 1: ...1 Rev 01 ...
