Version 1.1F
Operation Manual, JuniBox JB7210
D
EVICE
I
NSTALLATION
Finding a Place for JuniBox
JuniBox should be placed on a fairly level surface, firm enough to
support the unit and discs. Always allow ample workspace for your
operation, with easy access to the blank and finished discs.
Do not expose the unit to direct sunlight or high humidity, as it may
cause the unit to malfunction.
If you desire, JuniBox can be placed on a raised block so there is
ample room to receive discs from the Finish Disc Slot. Please refer to
the “More Than 30 Discs in One Session” section for details.
Using the Detachable Legs
JuniBox is designed to work either with or
without detachable legs. Without the legs,
the Reject Disc Slot (recession) on
JuniBox’s base will hold up to 3 rejected
discs.
If your application doesn’t involve rejected
discs or separating a group of discs from
others, you may use JuniBox without the
legs. It is, however, recommended to use
the legs when possible.
The legs will raise JuniBox providing
sufficient room to accommodate additional
rejected discs, as well as easier access to
them beneath the unit.
Attaching legs to JuniBox is simple. Inserting one leg after another on
JuniBox’s base, match the leg to JuniBox (A to A’) and gently snap the
leg into the receptacle (B to B’) until it is firmly attached.
To remove the legs, gently press the notch (N) and pull it outward from
the
receptacle (B’).
JuniBox Installation
Follow the steps below to complete JuniBox’s hardware installation:
1) Place JuniBox on level surface so that it stands firmly on its legs.
2) Place the spindle box that came with the unit in front of JuniBox.
© 2008, Datatronics Technology, Inc.
13
