At any time, you can add (or remove) hardware to your DTV-05C computer and modify its capabilities.
The information in this chapter will instruct you on how to open the CHASSIS, Configure the Main Board to
recognize add-in hardware, and install optional devices.
3.1
Removing The Cover:
WARNING : make sure that the power to your systems, as well as any peripheral devices, is off before
removing the chassis.
Remove 2 screws located at the rear panel of the system. Use the pulling knob to pull out the system
from the chassis. The system tray contains the Main Board, hard disk, floppy disk and add-on card (option)
As you removing the system from the chassis, mark or label plugs for correct orientation to simplify
reassemble. Improperly plugging connectors or plugs can damage your system when you power it up.
Ready a tray to hold screws, and label the tray so you know where the screws will go for reassemble.
Since your system required different sizes of screws, keeping screws separated will save you time and minimize
frustration.
3.1.1 Tools
You will need a few simple tools to remove the DTV-05C Compact Line LAIN-Station Machine.
* Philips screwdriver
* Labeling material (tape, paper, pen) (optional)
* Cups or trays to hold various screws (optional)
3.1.2 Adding Add-On Card:
DTV-05C includes 3 slots for 16 bit add-on card, for additional peripheral.
3.2
Installing The Hard Disk:
9
Summary of Contents for DTV-05C
Page 15: ...Dealer Information 15...