12
needle will clear the Wi-Fi password of the BC-100.
10. RS-232/RS-422
This port is used to connect to an Ethernet cable to
control the camera through the RS-232 or RS-422
protocol.
11. SDI OUT
These two SDI output connectors can be connected to
different back-end devices such as recorder and look-
back monitor. They can be combined with one HDMI
output port on the rear panel of the BC-100 to
simultaneously output two SDI and one HDMI signals
12. HDMI OUT
This HDMI output connectors can be connected to
different back-end devices such as recorder and look-
back monitor. It can be combined with two SDI output
ports on the rear panel of the BC-100 to simultaneously
output one HDMI and two SDI signals
13. DIP Switch
The 4 position Dip Switch is used for controlling modes
of the BC-100. For the details of the BC-100 dip switch,
please refer to
14. LANC Remote Control Interface
This remote connector is used for users to connect the
BC-100 to an external recorder such as Atomos Ninjia
Blade 5” HDMI Recorder/Monitor/Player with a 3.5mm
TRS/3 pin plug for remote controlling by LANC interface.
