6
Operation Procedure:
Step_1.
Select the desired mode by setting the dip switches. Reboot the DAC-10 after changing
the dip switches
Step_2
. Install the equipment as shown in installation diagrams
Step_3
. Ensure that all equipment is turned on
Step_4.
Select the video source. If the video source is analog, select the desired audio sampling Rate
Step_5
. Playback the source video
Step_6
. If needed, calibrate the playback video and audio output level
Step_7
. To generate an analog Color Bar output, under the DV mode, press on the “16 BIT” key. The
Color Bar will output from YUV,S(Y/C) and Composite video jacks at the same time. Press on the “16 BIT”
key again back to normal operation.
