EXPORTING TO
(
)
6
1. Connect the S-Video and RCA audio cables from the VCR’s Line input to the output on the DAC-100.
2. Connect the FireWire cable to the DAC-100, connect the opposite end to the PC or Mac’s FireWire Port.
3. Power on the DAC-100 and the VCR.
4. Start the Editing Software. (Not Supplied)
5. Press the DAC-100’s Source Button to switch it to “DV” and the A Encode Button to “16 bit”.
6. Go to the “Export” mode on the Editing software to begin exporting video to the VCR.
FireWire
REAR VIEW
Set to “16 bit”
Set to “AV”
PUSH
PUSH
Set to “16 bit”
FireWire to
PC/MAC
SOURCE
A ENCODE
How to Export Video from the computer back to Tape
DAC-100 Output Side
