24
presented to the editing system starts with the External value of the first
frame of the content; if this value is invalid then 00:00:00:00 is substituted.
6.7 Set up Synch to Tape
DN-60A recording sessions can be synchronized to the camera’s record
button by turning Sync to Tape ON. Whenever the tape deck in the camera is
rolling, so will the DN-60A time code. The DN-60A recognizes this
information and will record along with the camera deck. When the deck
stops, the DN-60A will pause the recording automatically. To record
continuously without regard for tape or deck motion, switch Sync To Tape
off. Some cameras control the DN-60A directly through the IEEE-1394
interface and in these cases use Sync To Tape off and let the camera control
the DN-60A unit.
6.8 Set the Audio Sampling Rate in the source
equipment
The DN-60A can only record audio at the 48KHz (16bit) audio sampling rate.
Please ensure the source camera or equipment is set to output at the 48KHz
(16bit) rate as the 32KHz (12bit) setting is not supported by the DN-60A.
6.9 Set the record date (optional)
As the source is digital the record date from the cameras digital stream can
be used. This feature is available in non HDV modes under Setup mode,
Record Set up, Record Date.
6.10 Before starting to Record
Select an empty Bin. An empty Bin will display as 00:00:00:00 on the DN-60A.
Before using your DN-60A for the first time, there are a few basic operational
settings that must be chosen. These are found under Setup Mode
6.11 Starting the Record Process
Common ways of starting to record with the DN-60A are:
Summary of Contents for DN-60A
Page 1: ...1 ...
Page 42: ...42 Service and Support ...