14
Firmware Update Procedure
Datavideo usually releases new firmware containing new features or reported bug fixes from time
to time. Customers can either download the firmware from our official website or contact their
local dealer or reseller for assistance.
This page describes the firmware update process and it should take
approximately 20 minutes to
complete
.
Once started
the update process should not be interrupted in any way
as this could result in a
non-responsive unit.
To start the firmware update procedure, you will need:
The latest firmware update for the
AD-1J
units
and
the
MCU-100J
.
USB 2.0 cable with a USB A type connector and a Micro USB connector.
A Computer with a USB 2.0 port running Windows Vista or 7.
Note:
It is recommended to update the firmware of the
AD-1J
unit(s) at the same time as the
MCU-100J
.
How to update the MCU-100J firmware
1.
Turn off the MCU-100J device power.
2.
Connect the MCU-100J to PC via a USB cable.
3.
Set the five
switches on the MCU-100J to their middle position.
4.
Move
switch up towards
(AWB)
and at the same time also press
the
shutter select
button.
Hold both in place.
5.
Turn on the MCU-100J power.
6.
MCU-100J LED display will show “
L-x.x
”, and the PC will find MCU-100J by USB 2.0.
7.
Open “
MCU-100J_U1
” folder on PC.
8.
Delete the
bootcode.bin
file in “MCU-100J_U1” folder.
9.
Copy new
xxxxxxxxx.bin
file to the “MCU-100J_U1” folder. Do not worry about the new file
name; the MCU-100J will amend the file name automatically after reboot.
10.
Reboot MCU-100J.
How to update the AD-1J firmware
1.
Connect AD-1J to PC via a USB cable
2.
Power on PC
3.
Copy the XXXXXXX_XXXXX.bin file to AD-1J from the PC.
Note:
It is recommended to update the firmware of the
AD-1J
unit(s) at the same time as the
MCU-100J
.
