10
Press and hold one of the
STREAM
button, the
RECORD
button and
the
STREAM
button until the pressed button starts blinking red.
Continue holding down one of the
STREAM
button, the
RECORD
button, and the
STREAM
button while pressing the
BITRATE
button to switch
bitrate mode (H, M or L).
Note: The system will return to the previous setting if the BITRATE button push
is not sensed. The default bitrate is M.
H/M/L LED Indicators
ON (Green)
: Bitrate mode enabled
OFF
: Bitrate mode disabled
STREAM Button
The
STREAM
button activates and deactivates
simultaneous recording and streaming; follow the steps outlined
below:
Start recording/streaming simultaneously
When idle, the
STREAM
button is solid white.
Press and hold the
STREAM
button for approximately 2 seconds
(
Note: the previously activated mode will be disabled
).
When the record and stream functions are activating simultaneously, the
STREAM
button turns from solid white, then blinking red and finally
to solid red.
When the
STREAM
button turns solid red, this indicates that the
record and stream functions have been successfully activated.
Stop recording/streaming simultaneously
While recording and streaming simultaneously, the
STREAM
button
is solid red.
Press and hold the
STREAM
button for approximately 2 seconds.
When the record and stream functions are terminating, the
STREAM
button turns from solid red, then blinking red and finally to solid white.
When the
STREAM
button turns solid white, this indicates that the
record and stream functions have been successfully terminated.
Summary of Contents for NVS-33
Page 1: ...NVS 33...
Page 56: ...56 5 Dimensions All measurements in millimeters mm...
