c) To select an Animation effect, press the "ANIMATION" key, then enter a
number from 25 to 52. These numbers correspond to pre-programmed
Animation patterns, as illustrated below:
d). To select a User-Programmable effect, press the "ANIMATION" key, then
enter a number from 95 to 99. To learn how to program your own effects,
refer to "ANIMATION SET UP SUB-MODE", (section 5.2).
Note: The Fade effect can be used in both automatic or manual playback
modes. In manual mode, the T-bar is used to control the Fade. Wipe and
Animation effects are available only in automatic playback mode. However,
during auto playback of a Wipe or Animation effect, you can manipulate the
T-bar at the same time to achieve a simultaneous Wipe/Fade or
Animation/Fade.
14
5.0.2 Before entering Program Sub-Mode.
The Program Sub-Mode will allow you to program Fades, Wipes (24 patterns),
Animation effects (24 patterns), and User-Programmable effects (up to five).
These effects are coded with numbers as described below. Refer to these
number codes as you read through the Program Sub-Mode section.
a) To select a Fade, press the "ANIMATION" key (same as the "PAGE" key), then
enter the number 00.
b) To select a Wipe effect, press the "ANIMATION" key, then enter a number
from 01 to 24. These numbers correspond to pre-programmed Wipe patterns,
as illustrated below:
1 2 3 4 5 6
1 2 3 4 5 6
7 8 9 10 11 12
7 8 9 10 11 12
13 14 15 16 17 18
13 14 15 16 17 18
19 20 21 22 23 24
19 20 21 22 23 24
25 26 27 28 29 30
25 26 27 28 29 30
31 32 33 34 35 36
31 32 33 34 35 36
37 38 39 40 41 42
37 38 39 40 41 42
43 44 45 46 47 48
43 44 45 46 47 48
49 50 51 52
49 50 51 52
